This is the GenRight Off Road design Double Triangulated 4 link cross member only kit for a Jeep TJ or YJ. Ideal to make your rig a top Notch rock crawler with awesome articulation. We have figured out all the mounting points to optimize suspension geometry, weight transfer, minimal Rear steer and proper amount of anti-squat for you, while keeping it all under the Jeeps floor. The cross member is pre-welded, but still needs to be welded to the frame by the installer. The Cross member kit is designed to attach to the frame next to where the transfer case skid plate, aftermarket or stock. This is the exact same Rear suspension cross member we use in the Jordans 4585 Modified Class KOH racer!Features:
Fits Jeep Wrangler TJ, LJ, YJ, or CJ
Mount is cut at an angle to keep the suspension joints in a neutral position so they Do noot waste any of the joints rotation and cause damage to the joint in those Crazy articulation spots on the trail
Kit is designed for Johnny Joints or Big -16 FK Heims
All Joint mounts are 2.625 inch spacing
All Joint mounts are for 9/16 inch bolts
Double triangulated 4 link design eliminates the need for a Rear trac bar, allowing you to Stretch the Rear axle back
This mount is universal and can be cut or trimmed to be mounted in any position on any Jeep TJ, LJ, YJ or CJ
This cross member is Not held in place by the transfer case skid plate. This allows unobstructed access to the transmission and transfer case for service
Unpainted Finish
Sold As A Kit
Includes:
Laser cut from Heavy Duty 1/4 inch and 3/16 inch thick cold rolled steel
MIG Welded by GenRight Off Road craftsmen
Includes everything pictured
We recommend the following to help Complete the project:
Use our Belly Up skid plate for the TJ/LJ, YJ which is designed to work with this cross member and it Will help locate this cross member in the proper place on the frame
Consider converting to coil over shocks at the same time you install this cross member kit. Our shock mount it Will make installing this Rear suspension much easier
Use our outboard mounted Rear shock kit P/N RSM-1001 to make relocation of the spring and shock, to a coil over type shock which is easier and provides better shock dampening control
Use our Transmission Cross Member Kit P/N BKT-1050 to isolate the transmission and transfer case from the belly skid plate
Our Rear Sway Bar kit P/N SWB-1003 for better on-road stability
Our EXT or Comp gas tanks Will allow you to lengthen the drive line and take advantage of all the Rear suspension articulation
Notes:
This kit requires cutting and welding for proper mounting to the vehicle
We also sell this as a Complete kit SUP-4201 with everything you need - links, joints, axle side mounts and hardware
Requires a 1 inch body and engine lift
Because this double triangulated type suspension changes the vehicles roll center resulting in great articulation, it has Noresistance which can make the vehicle feel a little knife edge. Therefore, it is Not recommended for vehicles driven on the street more than 10 percent
Add our Rear Sway Bar Kit P/N SWB-1003 for better on-road stability
We now offer universal Rear axle bridges for 14 Bolt and Dana 60 Rear axles
Will Not work with Atlas 4 Speed Transfer Cases, they are just too Big
VIDEO 
