Jeep Gas Tank Stretch 22 Gal w/Steel Skid 07-Present Wrangler JK 2 Door Aluminum Bare GenRight

This is the New tank from GenRight Off Road to Stretch the Rear axle back up to 5 inches on the 2 door Jeep JK! Building your JK into the ultimate rock crawler? Then we have the tank so you can put a 4-Link Rear suspension in you Jeep JK. This is the GenRight Crawler Gas Tank to fit a Jeep JK (2007-Present). It is specifically designed to Remove and replace the factory tank from under the middle of the vehicle so you can run true Rock Crawling triangulated 4 link Rear suspension (yes, Notrac bar). This tank follows in a line of innovative and trail proven, top quality gas tanks produced by GenRight. This New JK tank assembly is designed to fit in the Rear muffler area and mounts in a way that still works with your factory gas filler. It even reuses your factory fuel pump module so can work with all your factory emissions equipment so you Will Not get any check engine light or have Computer issues.
Features:

• Fits 2007-Present Jeep Wrangler JK 2-Door
• Reshaped tank creates room for up to 5 inches of Rear axle Stretch
• Rear mounted tank allows for the better triangulated Rear 4-link suspension systems
• Mounting location keeps center of gravity low
• Hi Clearance (no lower than the factory muffler, does Not hurt departure angle)
• 22 gallon fuel capacity
• Reuses the stock Jeep fuel pump module (or the Aeromotive Phantom)
• 1/8 inch thick Aluminum alloy tank is TIG welded
• Foam liner between tank and skid plate
• Includes a 3/16 inch thick heavy duty steel skid plate, powdercoated
• Stainless steel hold down strap
• All tanks are 100 percent pressure tested
• Patent Pending
• 100 Percent Made in USA!
• Unpainted Finish On Tank
• Black Powdercoat Finish On Skid Plate
• Sold As A Kit

Includes:

• Fully assembled fuel tank in a Heavy Duty skid plate
• New factory Mopar roll over/vent valves
• New tubing to adapt tank to New mounting location
• New Aluminum cargo area floor cover

Additional Notes:

• This tank was designed to be used with our 2 door JK Stretch suspension kit
• Because of shape and location changes, installation of this product requires changes to the exhaust
• Requires removal of the Rear floor tool storage area (the jack remains in the very Rear Compartment)
• To install this product it does Not require a body lift
• If a Rear sway bar is desired, installing this tank Will requires switching to a Currie AntiRock type Rear sway bars. Because the stock sway bar must be Removed
• For Off Highway Use in California